|
Irrigate your garden
Adequate soil moisture is essential
for good crop growth. A healthy
plant is composed of 75 to 90%
water, which is used for the plant's
vital functions, including
photosynthesis, support (rigidity),
and transportation of nutrients and
sugars to various parts of the
plant. During the first few weeks of
growth, plants are becoming
established and must have water to
build their root systems.
While growing, vegetable crops
need about 1 to 2 inches of water
per week in the form of rainwater or
irrigation water depending on the
type of soil. One thorough watering
each week is usually enough for most
soils. The soil should be wetted to
a depth of 5 to 6 inches each time
you water and not watered again
until the top few inches begin to
dry out. An average garden soil will
store 2 to 4 inches of water per
foot of depth. Keep a rain gauge
near your garden, then supplement
rainfall with irrigation water if
needed. In addition, there are ways
to reduce the amount of water you
have to add.
Reducing Water Demands
All of the water added to the
garden may not be available to
plants, particularly if the soil is
a heavy clay. Clay particles hold
soil moisture tightly; if, for
example, there are 4 1/2 inches of
water per foot of this type of soil,
there may be as little as 1 1/2
inches of this water available for
plants. A higher level of humus in
the soil, brought about by the
addition and breakdown of organic
matter, can increase the amount of
water available. By causing clay
particles to aggregate (stick
together), humus also adds air
spaces to tight clays, allowing
moisture to drain to lower levels as
a reserve, instead of puddling and
running off the top of the soil.
The moisture-holding capacity of
sandy soils is also improved by
additions of organic matter. Though
most soil water in sandy soil is
available to plants, it drains so
quickly that roots are unable to
reach water only a few days after a
rain. Humus in sandy soil gives the
water something to cling to until it
is needed by plants.
Addition of organic matter, then,
is the first step in improving the
moisture conditions in your garden.
Mulching is another a cultural
practice which can significantly
decrease the amount of water that
must be added to the soil. A 6 to 8
inch organic mulch can cut water
needs in half by smothering weeds
(which take up and transpire
moisture) and by reducing
evaporation of moisture directly
from the soil. Organic mulches
themselves hold some water and
increase the humidity level around
the plant. Black plastic mulch also
conserves moisture but may
dramatically increase soil
temperatures during the summer if
not covered by other mulch materials
or foliage.
Shading and the use of windbreaks
are other moisture-conserving
techniques. Plants that wilt in very
sunny areas can benefit from partial
shade during the afternoon in
summer. Young plants, especially,
need protection. Air moving across a
plant carries away the moisture on
the leaf surfaces, causing the plant
to need more water. In very windy
areas, the roots often cannot keep
up with leaf demands, and plants
wilt. Temporary or permanent
windbreaks significantly reduce this
stress.
Despite the use of these cultural
practices, your garden may need a
lot of water. When rainfall is
sparse and the sun is hot, watering
can benefit your garden with
increased yields. It may save the
garden altogether in a severe
drought.
Irrigation practices, when
properly used, can:
- Aid in seed emergence.
- Reduce soil crusting.
- Improve germination and
plant stand.
- Reduce wilting of
transplants.
- Increase fruit size of
tomatoes, cucumbers, and melons.
- Prevent premature ripening
of peas, beans, and sweet corn.
- Maintain uniform growth.
- Improve the quality and
yields of most crops.
Irrigation Methods
The home gardener has several
options for applying water to plants
including a sprinkler can; a garden
hose with a fan nozzle or spray
attachment; a portable lawn
sprinkler; a perforated, plastic
soaker hose; a drip or trickle
irrigation system; or a
semi-automatic drip system. Quality
equipment will last for a number of
years when properly cared for. When
making a decision as to which type
of watering equipment you will use,
there are a number of things to
consider.
The purchase of a specific type
of watering equipment depends upon
available water facilities, water
supply, climate, and garden
practices. If there is no outdoor
spigot near the garden, the expense
of having one installed may be
greater than the benefits gained,
except in very drought-prone areas
or in the case of a gardener who is
fully dependent on the season's
produce. Where rainfall is adequate
except for a few periods in the
summer, it is wise to keep watering
equipment simple. A rain barrel or a
garden hose with a fan-type
sprinkler may suffice; a water
breaker for small seedlings is
useful. In areas where there are
extended periods of hot weather
without precipitation, the local
water supply is likely to be short.
Since overhead sprinklers waste
water, a drip irrigation system may
be in order. Drip irrigation puts
water right at the roots and doesn't
wet plant leaves, helping to control
some diseases. Timers are available
that allow automatic watering with
drip irrigation systems.
Several types of drip or trickle
equipment are available. The soaker
hose is probably the easiest to use
as no installation is required. It
is a fibrous hose that allows water
to slowly seep out all along its
length. It is simply laid at the
base of the plants and moved around
the garden. There are also complete
kits containing attachments and PVC
hose with holes to allow gradual
water release. These are intended
for semi-permanent installation and
usually last 2 to 5 years. With this
type, a flow regulator usually has
to be included with the system so
that the water can reach the end of
the hose without being sprayed out
at full force. A special
double-walled type of irrigation
hose has been developed which helps
to maintain a more even flow.
Finally, there is the emitter-type
system, best used for small raised
beds or container gardens, in which
short tubes, or emitters, come off a
main water supply hose and go right
to the roots of the individual
plants. This is generally the most
expensive form of irrigation and the
most complex to set up, but it has
advantages. The weeds in the area
are not watered and evaporation from
the soil is minimized. This type of
system is best used in combination
with a coarse mulch or black
plastic. Drip systems can have
problems with clogging from soil
particles and/or mineral salts
suspended in water taken from
springs or wells. New designs take
this problem into consideration;
some include filters and
self-flushing emitters. It is wise
to make a complete investigation and
comparison before purchasing a drip
irrigation system.
Basic Techniques and Principles
for Watering
For overhead or sprinkler
watering, adjust the rate of water
application to about 1/2 inch per
hour. A faster rate will cause
run-off unless your soil has
exceptionally good drainage. To
determine the rate for a sprinkler,
place small cans at various places
within the sprinkler's reach, and
check the level of water in the cans
at 15-minute intervals.
When using the oscillating type
of lawn sprinkler, place the
sprinkler on a platform higher than
the crop (to prevent water from
being diverted by plant leaves), and
try to keep the watering pattern
even by frequently moving the
sprinkler and overlapping about half
of each pattern.
Wet foliage overnight can
encourage diseases, so do not use
sprinkle irrigation in the evening.
Morning watering is preferred as
there will be less water lost to
evaporation than in the heat of the
day. Add enough water to soak the
soil to a depth of 5 to 6 inches.
The amount required varies with the
nature of your soil. Frequent, light
waterings will encourage shallow
rooting which will cause plants to
suffer more during drought periods,
especially if mulches are not used.
On the other hand, too much water,
especially in poorly drained soils,
can be as damaging to plant growth
as too little water; it deprives the
roots of oxygen needed to grow.
By knowing the critical watering
periods for selected vegetables or
vegetable types, you can reduce the
amount of supplemental water you
add. This can be important,
especially where water supplies are
limited. In general, water is most
needed:
- during the first few weeks
of development
- immediately after transplant
- during development of fruits
Specifically, the critical
watering periods for selected
vegetables are:
| Asparagus |
Spear production, fern
development |
| Broccoli, Cabbage,
Cauliflower |
Head development |
| Beans, peas |
Pod filling |
| Carrot |
Seed emergence, root
development |
| Corn |
Silking, tasseling, ear
development |
| Cucumber, Melon |
Flowering, fruit
development |
| Eggplant, Tomato |
Flowering, fruiting |
| Lettuce |
Head development;
moisture should be constant |
In areas prone to repeated
drought, look for drought-resistant
varieties when buying seed or
plants.
If water supplies are short in
your area and you wish to use "grey
water" (water from household uses)
on your vegetable garden, a few
rules should be observed:
- Do not use any water run
through the toilet, because of
the possibility of contamination
from fecal organisms.
- Avoid the use of kitchen
waste water that contains grease
or harsh cleaners, ammonia,
bleach, softeners, or
non-biodegradable detergents.
- If using water from the
bathtub or washing machine, use
only mild, biodegradable soaps.
Omit softeners and bleaches.
Allow the wash and rinse water
to mix, if possible, to dilute
the soap content. Never use a
borax-containing product (such
as washing soda) in water to be
used on a garden because of the
danger of applying plant-toxic
levels of boron.
- Apply grey water to the
soil, not to plant leaves.
|